Arb 3915030 User Manual download pdf (Page 22)

Last Rev Date: 29/10/2008 Page 22 of 24 Fitting instructions# 3783321

FITTING PROCEDURE BAR ON VEHICLE

54. Wire up indicators and parking lamps.

Note:

Wire configuration of supplied indicator looms;

Black = ground

Green = indicator (amber)

Red = run lamp (clear)

55. Use supplied scotch locks for the electrical

connections then secure wiring with cable ties

when complete.

56. Wire up P# 6821201 ARB fog lamps if fitted.

NOTE: For vehicles without factory fog lamp loom,

use ARB Loom MD02 plus switch. Supplied tails

can be joined to OE loom

77. Using square file, increase slot length in 2 x

existing holes in sump guard (those pitched

570mm apart) to a size of 12.3mm A/F.

78. Fit two M8 cage nuts to slots in sump guard

(NOTE: nut body above panel as shown).

79. Fit stone tray using 4 x M8 bolts and washer

sets at front and 2 x M8 bolts, washers and

into fitted M8 cage nuts at two locations into

existing sump guard front section as shown.

72. Trim fender liner if required. Tuck behind

wing return.

73. If required secure with cable ties through

holes in bulkhead.

View from

underneath

View from top

Running

lamp wiring

Indicator

lamp wiring

1 2 ... 17 18 19 20 21 22 23 24

No comments

Arb 3915030 User Manual Page 22