Arb 3915030 User Manual download pdf (Page 20)

Last Rev Date: 29/10/2008 Page 20 of 24 Fitting instructions# 3783321

FITTING PROCEDURE BAR ON VEHICLE

75. Using two people, three if winch fitted,

position the bar assembly on the vehicle

mounts.

Caution: This product is heavy, especially if a

winch is fitted. Do not attempt to lift it and fit it

by yourself. Have some assistants help you or

use a mechanical aid such as a hydraulic lift

table.

76. Bolt the bar to the mounts using M12 bolts.

Large flat washers and spring washers.

Centralise the bar to the front of the vehicle.

Do not tighten any bolts yet

77. Fit the cross brace to underside of lower pan

and on top of gussets in mount brackets. Use

M10 x 30mm SEMS bolt and washer sets,

flange nuts but do not do up tight. If holes in

pan do not line up, run a Dia 10.0 drill through

any holes to enable bolt entry.

78. Tighten up the mount brackets fasteners.

Start with the tow hook bolts, then M10 flange

nuts to chassis studs.

79. Then tighten up the long M12 chassis studs,

ensuring that the clevis nut is positioned

correctly over the hole in the chassis.

NOTE: Protrusion as shown is approximately

7mm.

80. Adjust the bar height leaving approximately

25mm gap between top of wing to fender.

Align the bar so the front face is vertical and

the gap is even on both sides of the vehicle.

25mm

gap

Warning: Drilling operations can result in

flying metal debris, safety glasses should be

1 2 ... 15 16 17 18 19 20 21 22 23 24

No comments

Arb 3915030 User Manual Page 20