Arb 3915030 User Manual download pdf (Page 16)

Last Rev Date: 29/10/2008 Page 16 of 24 Fitting instructions# 3783321

FITTING BUFFERS or BUFFERS WITH FRAME

BUFFERS ONLY

51. With sahara bar sitting as it would when fitted

to vehicle, fit each buffer in turn and secure

with M6 flange nuts on 6 x studs per side

once buffers are carefully pushed home

against the profile of the bull bar be careful

not to over tighten the flange nuts as damage

to buffer can result.

BUFFERS AND FRAME

52. Place the sahara bar face down on a soft

surface

53. Fit the RH hinge bracket assembly to

outboard side of upright as shown, with M10

bolt, large M10 washer, spring washer, flange

nut, bush and 16mm ID nylon washer.

Tighten to recommended torque.

NOTE: The top flange of hinge bracket must face

inboard, ie top flanges are towards each other

when fitted

54. Repeat for LHS.

NOTE: When the frame sits on the bumper, it is

angled backward. Put it up against the bumper

and determine which side is LH and RH. The

buffers are handed RH and LH. Select the

correctly handed buffer to fit over each end of

the frame before proceeding.

55. Slide the buffers over the frame as shown

M10 x 30 bolt

Spacer bush

M16 nylon washer

Large M10 washer

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Arb 3915030 User Manual Page 16