Arb 3915030 User Manual download pdf (Page 15)

Last Rev Date: 29/10/2008 Page 15 of 24 Fitting instructions# 3783321

FITTING PROCEDURE BULL BAR PREPARATION

FITTING NUMBER PLATE

50. If winch fitted, apply double sided tape strip

to top back of number plate. If winch not

fitted, no adhesive strip is required.

51. Fit grommets to slots, with split horizontal as

shown

52. Fit number plate using supplied pan head

screws into grommets.

WITH WINCH

45. Fix using the lower holes in number plate as

shown

WITHOUT WINCH

46. Fix using upper holes in number plate as

shown.

53. In lower inside face of pan, fit M8 cage

nuts for stone tray in four positions as

shown.

Hint: You can use a flat blade screwdriver to

push the remaining cage nut leg into the hole

IF NOT FITTING WINCH

47. Wrap rubber extrusion around winch cover,

trim to length.

48. Place M6 st stl flat washers over holes in the

top face of the bull bar where the winch cover is

fixed to the bull bar.

NOTE: The M6 washers support the cover and

prevent dipping around the screw heads

49. Place the winch cover in position as shown with

screws aligning through the mount holes and

leaving the washers in place.

50. Bolt together using the M6 button head

stainless steel screws, washers and M6 nuts.

Split horizontal

The narrower section of the plate is to front

of bull bar

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

No comments

Arb 3915030 User Manual Page 15