Arb 3936020 User Manual download pdf (Page 7)

13/6/08

Page 7 of 11

3786946

10.

The roller fair lead must be drilled prior to

fitment.

Using a 13.0 mm drill bit drill two holes as

shown in diagram.

11.

If fitting winch.

Viewed from front of vehicle the winch clutch

must be positioned on the LH side. Cable

spools from the bottom. Bolt in position with

the roller fair lead in place. Draw off some

cable so cable crimp can be pulled through

roller fairlead.

If crimp is too large to fit through, remove a

circlip from a horizontal roller, partially remove

the shaft so roller gap is increased and feed

cable and crimp through. Refit shaft and

circlip. Bolt in position with the roller fair lead

in place.

Note; To increase access to mount bolts in

front of roller fairlead, remove circlips from

bottom of each vertical roller shaft, push shaft

up so roller can be dislodged sideways. Do up

bolts in fairlead and winch, then refit circlip.

Connect the winch control box cables to the

winch motor. Refer to the Warn handbook for

additional information. Connect the long winch

+ & - cables to the vehicle after the bar is

installed. Refer to the Warn winch manual

for vehicle wiring instructions.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Arb 3936020 User Manual Page 7