Arb 3936020 User Manual Page 1

13/6/08 Page 1 of 11 3786946 If you have any queries regarding the installation of this product please contact the distributor from whom it was purch

13/6/08 Page 10 of 11 3786946 18. The bar must be pin bolted to the mount brackets. Using a drill and 10mm drill bit, drill through the upper and l

13/6/08 Page 11 of 11 3786946 21. If fitting with winch Feed the winch cable through the roller fair lead. Mount the hook to the end of the cable.

13/6/08 Page 12 of 11 3786946

13/6/08 Page 2 of 11 3786946 USE PART No QTY DESCRIPTION BUFFER FITTMENT (5100171 REQUIRED IF FITTING T

13/6/08 Page 3 of 11 3786946 TENSION BRACKET 3756432 2 TENSION BRACKET 6151255 4 BOLT M12 X 40mm 4581050 4 WASHER SPRIN

13/6/08 Page 4 of 11 3786946 ASSEMBLY SEQUENCE FOR WINCH BUMPER. 1. Position the lower buffer on the winch bumper and assemble using the M6 flange

13/6/08 Page 5 of 11 3786946 4. Remove the bumper and two recovery hooks. Fit M12 cage nuts to slots on each mount bracket as shown and fit mount

13/6/08 Page 6 of 11 3786946 7. Bend the end of the strap inward, as shown, to allow the strap to sit against the bull bar mounting bracket. Drill

13/6/08 Page 7 of 11 3786946 10. The roller fair lead must be drilled prior to fitment. Using a 13.0 mm drill bit drill two holes as shown in dia

13/6/08 Page 8 of 11 3786946 12. Fitting with winch Fitting without winch If fitting with winch. Peel off one side of the double sided tape and ad

13/6/08 Page 9 of 11 3786946 15. Bolt the deflector to the original bolts located in the chassis cross member. Tie the power steering lines to the