Arb 3936020 User Manual download pdf (Page 11)

13/6/08

Page 11 of 11

3786946

21.

If fitting with winch

Feed the winch cable through the roller fair

lead. Mount the hook to the end of the cable.

22.

If you have fitted the optional fog lights, the

base of the fog light surround must be

removed. Carefully cut the 4 retaining tabs with

a knife.

Glue the light surrounds to the bar using a

silicone based rubber adhesive. Run the bead

along the cavity on the rear side of the part.

Position the surround to align the inside edge

with the buffer and concentric to the light.

Wipe off any adhesive on the front face of the

bar. Allow adhesive to cure before continuing.

23.

There are two Ø16 holes located on the top

face of the bar. If no CB aerials are fitted the

holes can be covered with the plastic plugs

provided in the fitting kit.

Place the ARB logo on the front face of the bar

in the indentation.

24. If fitting fog lights, wire the fog lights as described in the fog light fitting instructions.

The fog lights can be adjusted to desired angles by the adjustment bolts located at the back of the light

insert. When adjustment is finalized, be sure to retighten the fog light bolts.

If fitting with winch.

25. Connect the long winch + & - cables to the vehicle after the bar is installed.

Refer to the Warn winch manual for vehicle wiring instructions.

Ensure that these cables are installed well clear of sharp, hot or moving objects. Secure the

winch cables to the vehicle and winch bumper with the supplied cable ties.

1 2 ... 6 7 8 9 10 11 12

No comments

Arb 3936020 User Manual Page 11