Arb 3936020 User Manual download pdf (Page 6)

13/6/08

Page 6 of 11

3786946

7.

Bend the end of the strap inward, as shown, to

allow the strap to sit against the bull bar

mounting bracket.

Drill through the strap and bracket using a

12.5mm drill bit and bolt up using the same

hardware as described in the above step.

IMPORTANT: STRAP POSITION MUST BE

AS LOW AS PRACTICAL ON MOUNT

BRACKET AS SHOWN.

8.

If fitting winch.

The clutch handle must be repositioned so it is

in a convenient location when mounted to bar.

Place the winch on its end and remove all

gearbox bolts.

Gently raise the motor just enough to rotate it.

Viewing from the gearbox end, rotate the

gearbox 72deg clockwise.

Do not completely remove the motor and avoid

damaging the gasket.

Refit and tighten all bolts.

Note: Take care not to lift the assembly more

than a couple of millimeters while rotating to the

desired position to avoid un-meshing the gears.

9.

If fitting winch.

The three control box leads, which connect to

winch, need to be replaced with the longer

leads supplied in the fitting kit. Replace the

leads with the same colours.

Bolt the control box bracket to the control box,

refer photo.

Fit the two grommets into the round holes then

thread the cable through.

Mount the control box bracket onto the top

pan, using M8 bolts, flat washers and flanged

nuts. Use the cables ties to ensure the winch

cables are secure, tying them together.

ORIGINAL POSITION

NEW POSITION

ROTATION

Drill Dia

12.5mm hole

for pinning

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments