Arb 3415120 User Manual download pdf (Page 2)

Last Rev Date: 17 SEPTEMBER 2008 Page 2 of 20 Fitting instructions# 3783312

GENERAL CARE AND MAINTENANCE

By choosing an ARB Bar, you have bought a product that is one of the most sought after 4WD products

in the world. Your bar is a properly engineered, reliable, quality accessory that represents excellent

value. To keep your bar in original condition it is important to care and maintain it following these

recommendations:

 Prior to exposure to the weather your bar should be treated to a Canuba based polish on all exposed

surfaces. It is recommended that this is performed on a six monthly basis or following exposure to

salt, mud, sand or other contaminants.

 As part of any Pre Trip Preparation, or on an annual basis, it is recommended that a thorough visual

inspection of the bar is carried out, making sure that all bolts and other components are torqued to

the correct specification. Also check that all wiring sheaths, connectors, and fittings are free of

damage. Replace any components as necessary. This service can be performed by your local

authorized ARB Stockist.

FITTING REQUIREMENTS

REQUIRED TOOLS FOR FITMENT OF PRODUCT:

Metric socket and spanner sets 8-25mm range External Circlip pliers

Screwdrivers, Philips and Flat blade Power Jigsaw with blade for plastic cutting

Short Body Power Drill 13mm (1/2”) capacity Dia 7.0mm (5/16”) and 10.5mm (25/64”) drill bits

Tin snips Marking pen

Half round file Soft Hammer

Metric hex key set Loctite© 262 or equiv.

Wide masking tape Stanley knife

Small Spirit Level Tape Measure & 2 x 300mm rulers

If fitting parking sensors: Dia 22.0 (7/8”) hole saw Paint black fast drying

HAVE AVAILABLE THESE SAFETY ITEMS WHEN FITTING PRODUCT:

Protective eyewear

Hearing protection

NOTE: ‘WARNING’ notes in the fitting procedure relate to OHS situations, where to avoid a

potentially hazardous situation it is suggested that protective safety gear be worn or a safe work

procedure be employed. If these notes and warnings are not heeded, injury may result.

FASTENER TORQUE SETTINGS:

SIZE Torque Nm Torque lbft

M6 9Nm 7lbft

M8 22Nm 16lbft

M10 44Nm 32lbft

M12 77Nm 57lbft

OPTIONAL LIGHT SETS TO SUIT THIS PRODUCT:

♦ FOG LAMP SET P# 6821201 ADD GXL ONLY P#MD02 LOOM KIT, P#180209 SWITCH AND

P#180215 SWITCH CAP FOR FOGS

♦ UP TO IPF 900 SERIES FOG OR DRIVING LIGHT SETS

♦ IPF 840 FYS

FOG LIGHTS CAN BE FITTED TO LOWER PAN AREA

1 2 3 4 5 6 7 ... 19 20

Comments to this Manuals

No comments

Arb 3415120 User Manual Page 2

Comments to this Manuals

Related products and manuals for For the car Arb 3415120