Arb 3415010 User Manual download pdf (Page 9)

Last Rev Date:29/10/2008 Page 9 of 20 Fitting instructions# 3783250

REMOVAL OF BUMPER

23. Mask up and spray paint the exposed metal

trim area black satin, from the wheel arch

right around to the inboard headlamp area as

shown, both sides of the vehicle.

NOTE: This is in the area where the bumper

cover retaining brackets were removed at step

22. When the bull bar is fitted there will be

25mm of this sheetmetal visible, the black

masks the visible gap.

FIT MOUNTING BRACKETS

24. Insert clevis nut into rectangular hole in the

inboard face of chassis, ensuring the

threaded end is inserted first.

The nut when fitted correctly should fit square

and locate into the chassis rail.

25. Install the chassis stud by fitting 2 nuts to the

end of the stud and tightening until thread

bottoms out.

26. Remove nuts and repeat for the LHS.

27. Loosely fit the mounting brackets to the

chassis securing with the 8mm packers and

flange nuts.

28. Secure using existing OE M10 flange nuts,

but do not do up tight

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

No comments

Arb 3415010 User Manual Page 9