Arb 3415010 User Manual download pdf (Page 12)

Last Rev Date:29/10/2008 Page 12 of 20 Fitting instructions# 3783250

FITTING PROCEDURE BULL BAR PREPARATION

39. Secure the number plate bracket using

M6 bolts, flat washers and flange nuts.

Attach the longer side to the bullbar and

the shorter side to the number plate.

40. Fit M8 cage nuts for stone tray in four

positions to inside face of lower pan.

FITTING PROCEDURE WINCH

If fitting winch.

41. The clutch handle must be repositioned

so it is in a convenient location when

mounted to bar.

Place the winch on its end and remove all

gearbox bolts.

Gently raise the motor just enough to rotate

it. Viewing from the gearbox end, rotate the

gearbox 72° clockwise.

Do not completely remove the motor and

avoid damaging the gasket. Refit and tighten

all bolts.

Note: Take care not to lift the assembly

more than a couple of millimeters while

rotating to the desired position to avoid

un-meshing the gears.

42. Remove cable retaining band and position

cable loop so it will go through roller

fairlead when it is placed in bull bar.

ORIGINAL POSITION NEW POSITION

ROTATION

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Arb 3415010 User Manual Page 12