03/12/04 Page 5 of 11 3782893
ASSEMBLY SEQUENCE FOR BULLBAR.
1. For pre 09-2002 models use vice grips, multi grips
or pliers bend back the bumper mounting arm
approximately 90 degree’s to clear winch bumper
when assembled.
1. On models built after 09-2002 if you are fitting a
10000lb or 12000lb winch you will need to remove
the upright support and cut a section of it out.
1. Once removed hold the upright in a vice and cut out
the section shown with a hacksaw.
2. Replace the upright and continue fitting the winch.
Comments to this Manuals