Arb 3438320 User Manual download pdf (Page 11)

Last Rev Date: 17/11/2009 Page 11 of 18 Fitting instructions# 3787059

WINCH FITMENT ONLY

IF FITTING A WINCH

39. Rotate the winch motor 90 degrees as shown,

so that the terminals are facing upwards once

winch is fitted to bull bar

NOTE: Follow the winch manufacturers

instructions regards motor rotation and

drainage requirements

40. Remove the cap head screws retaining the

gearbox to the winch drum. Carefully lift the

gearbox a small amount (5 mm ) and

rotate144 degrees counter clockwise (four

hole spacings) and re-fit the cap screws . This

places the winch handle in the correct

orientation.

41. Lay the winch on a suitable flat surface and

place the bull bar on top so that the wire rope

will feed thru from the bottom.

42. Using the two 3/8” x 1 1/2”long bolts, M10 flat

and spring washers, attach the bull bar to the

winch through the top two bolt holes as

shown.

Fit two top 1 ½” long

bolts first

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Arb 3438320 User Manual Page 11