Arb RD142 User Manual download pdf (Page 18)

3 Installing the Air Locker

NOTE : Use an automotive brake line tubing cutter to cut the

seal housing tube, never a hacksaw as this will leave

metal filings in the air system.

 From the inside of the housing, insert the trimmed tube into the

bulkhead.

 From the outside of the housing, assemble the small O-ring over

the top of the short length of seal housing tube protruding through

the bulkhead fitting.

 While holding the seal housing tube into the bulkhead fitting, insert

the small drilled end of the center compression nut over the

extended tube as shown in the assembly diagram (Fig.10.), and

screw it into the bulkhead body, and lightly tighten.

NOTE : Be sure to insert the correct end of the center

compression nut into the bulkhead body. The thread

has been partially relieved on the bulkhead side of the

center compression nut to visually identify its

orientation. (Fig.10.)

Figure 10.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

No comments

Arb RD142 User Manual Page 18