Arb 3450080 User Manual download pdf (Page 2)

20-5-98 Page 2 of 4 3782549

TOOLS REQUIRED

Basic tool kit, drill and ½” drill bit

PROCEDURE

1. Place the bull bar onto a suitable stand.

2. New mounting holes must be drilled in the roller fairlead in order to line up with the winch

mounting holes in the bull bar. (Refer to diagram 1.)

DIAGRAM 1

3. Remove the circlips which retain the side pins.

4. Remove the side pins and side rollers from the roller fairlead.

5. Position the roller fairlead hard up against the roller fairlead bracket on the bull bar.

6. From the rear of the bull bar, using the holes in the bull bar as a guide, mark out the new hole

position on the roller fairlead and drill out to ½”.

7. The winch clutch handle must be rotated to be easily accessible when fitted into the bull bar.

Remove all the Allen screws retaining the clutch and gearbox. Rotate this assembly clockwise so

the handle can be reached from the cut-out in the bull bar on the passenger side.

DIAGRAM 2

NOTE: Take care not to lift the assembly more than a couple of millimetres while rotating to the

desired position to avoid unmeshing the gears.

8. Refit all bolts and tighten.

9. Fit the rubber grommet to the hole in the top of the bull bar.

10. Mount the control box to the control box bracket using the original nuts on the control box.

1 2 3 4

No comments

Arb 3450080 User Manual Page 2